Friday, May 3, 2013

RIPv1 Configuration


Today we Configured a topology but we installed RIPv1 into the configuration. RIPv1 uses Classful updates and broadcasts the networks that are connected to that router. This first thing we did was build the topology. We needed a network that had 3 1941 routers, 1 2911 router(with Loopback), and switches connected to the routers. After we installed the WIC2T's cards and connected the routers and switches correctly, we allocated the ip addresses of the interfaces and networks. We basically configured each router carefully, then made sure they were all connected. Finally we installed RIPv1 onto each Router:

1) Enter Configuration mode: Router#config
2) Enter RIP configuration: Router(config)#router rip
3) Now while you are in RIP configuration, you must add the networks that that router knows.
       Router(config-router)#network 1.1.1.0

I continued to configure the Routers using RIP .



No comments:

Post a Comment